RPM Mach One
5 Year Member
A 67 fast back conversion for Mrs. bbettto !
- Thread starter horse sence
- Start date
-
Sponsors (?)
The old back is all better now.
Got most of the interior brackets in today with a bit of welding it still needed. The floor patches are trimmed ,just need to cut out the floor.
All that should be left is the front apron patches and radiator support . Hope to have it finished by the week end .
Got most of the interior brackets in today with a bit of welding it still needed. The floor patches are trimmed ,just need to cut out the floor.
All that should be left is the front apron patches and radiator support . Hope to have it finished by the week end .
The passenger side rear floor patch is done . The driver front is cut out but looks like the toe board is also toast ,i think i have one here.
The toe board is in ,i just need to finish welding .
I was hoping to finish without needing to refill my welding tank ,i dont have much left to weld ,what do you think ,will i make it ?
I was hoping to finish without needing to refill my welding tank ,i dont have much left to weld ,what do you think ,will i make it ?
Similar threads
